§15§Das Buch stellt den aktuellen Stand der kompletten Befestigungstechnik für Beton und Mauerwerk mit Einlegeteilen (Ankerschienen, Kopfbolzen), Dübeln (Metallspreizdübel, Hinterschnittdübel, Verbunddübel, Betonschrauben, Kunststoffdübel) und Setzbolzen umfassend dar. Die Befestigungselemente und ihre Wirkungsmechanismen werden ausführlich beschrieben und das Tragverhalten im ungerissenen und gerissenen Beton untersucht. Weiterhin werden das Korrosionsverhalten, das Verhalten bei Brandbeanspruchung sowie bei Erdbeben- und Schockbeanspruchung behandelt. Von besonderer internationaler Aktualität ist die Bemessung gemäß der europäischen und amerikanischen Normung.§Praxisorientierte Kriterien zur Auswahl von Befestigungsmitteln und Bemessungsbeispiele runden das Werk zu einem einzigartigen Handbuch ab.§ §03§Introduction§Fastening systems§Principles§Behaviour of headed studs, undercut anchors and metal expansion anchors in non-cracked and cracked concrete§Behaviour of cast-in anchor channels in non-cracked and cracked concrete§Behaviour of bonded anchors in non-cracked and cracked concrete§Behaviour of plastic anchors in non-cracked and cracked concrete§Behaviour of power actuated fasteners in non-cracked and cracked concrete§Behaviour of screw anchors in non-cracked and cracked concrete§Behaviour of anchors under seismic loading§Behaviour of anchors in fire§Corrosion of anchors§Influence of fastenings on the capacity of components in which they are installed§Design of fastenings§ §SD §16§A comprehensive treatment of current fastening technology using inserts (anchor channels, headed stud), anchors (metal expansion anchor, undercut anchor, bonded anchor, concrete screw and plastic anchor) as well as power actuated fasteners in concrete. It describes in detail the fastening elements as well as their effects and load-bearing capacities in cracked and non-cracked concrete. It further focuses on corrosion behaviour, fire resistance and characteristics with earthquakes and shocks. It finishes off with the design of fastenings according to the European Technical Approval Guideline (ETAG 001), the Final Draft of the CEN Technical Specification 'Design of fastenings for use in concrete' and the American Standards ACI 318-05, Appendix D and ACI 349-01, Appendix B. §04§Introduction§Fastening systems§Principles§Behaviour of headed studs, undercut anchors and metal expansion anchors in non-cracked and cracked concrete§Behaviour of cast-in anchor channels in non-cracked and cracked concrete§Behaviour of bonded anchors in non-cracked and cracked concrete§Behaviour of plastic anchors in non-cracked and cracked concrete§Behaviour of power actuated fasteners in non-cracked and cracked concrete§Behaviour of screw anchors in non-cracked and cracked concrete§Behaviour of anchors under seismic loading§Behaviour of anchors in fire§Corrosion of anchors§Influence of fastenings on the capacity of components in which they are installed§Design of fastenings§ § §02§ing at the University of California at Berkeley and is a Structural Engineer. He worked for ca. 10 years in San Francisco at two renowned engineering firms concentrating on inter alia fastenings during earthquakes. He worked in the development centre at HILTI for four years and currently works in their San Francisco offices.
